Avare ads b

Weather will work with the Stratus 3 ADS-B in Canada. Q: Does the subscription free weather work in Panama and Costa Rica? The Stratus 3 (11-14468) will not get weather in Panama or Costa Rica as no ADS-B IN is available.Q: Will this Stratus 3 fulfill the ads-b requirement for 2020 or is certified equipment required in 2020? This unit provides ADS-B In only. The 2020 mandate is for ADS-B Out requiring aircraft to be equipped.Q: Will Stratus 3 work with Avare app for Android? Per the manufacturer, at this time there is no compatibility with this app. Q: Does Stratus 3 allow me to share with my copilot or other users in the aircraft? Yes. In fact, every iOS device running ForeFlight Mobile in the cockpit can connect to Stratus at the same time.Q: Does the subscription free weather work on the Stratus 3 in Australia? The Stratus 3 (part # 11-14468) will not get weather in Australia. Q: Will the Stratus 3 work with the Fltplan.com app? Per Fltplan, is now compatible with the Stratus 3.Q: Does subscription free weather work with Garmin I-Fly 740? Per Stratus 3 website, yes, the iFly will receive free in flight weather.Q: Will the Stratus 3 ADS-B IN work with the Garmin 696 GPS? No, the Stratus 3 will not work with the Garmin 696.Q: Will the Stratus 3 work with ifly 740b unit? No, This will not work with the iFly 740b per iFly.

Or traffic. Stratux hands out .10 to the connected tablet. Need to go to .1 in the browser. #16 Yes, read about that issue and tried that. Didn't help.The Stratux is nice but if I have to fiddle with it to keep it functional... The juice might not be worth the squeeze. It's a rare Stratux build indeed that does not need ever need fiddling.I'm about to power up my old Stratux build to see if it still works. Friend of mine is instructing full time now and could use it. If it powers up and doesn't need more than a re-flash, I'll send it has way. If not, it'll just go in the garbage. #17 Hi.Go to Avare Forum, see URL below, and or look at the post below for more info: this post, see some info listed below: sure your Device is in Full power / Game mode.1-In your Tablet / receiving device, make sure WiFi is ON.2-Start your Stratux and wait until your device is booted up, Green LED starts to blink, or about 1min.3-In your Tablet, Connections>WiFi, make sure that you see Stratux and get it Connected, Do Not proceed beyond this point unless you have that satisfied. Note: If you are close to another WiFi source / Modem etc. you may not see the Startux, move to a different location.4-Start Avare, enable GPS and confirm that you do not see the " No GPS Signal", you can also verify at least 3 Green Satellites in Tools.5-In Menu Preferences Weather>Use ADSB Weather selected.6-Create a Flight Plan in the area, may not be needed.7-Send Avare to background, do not exit, Home key.8-Sart Avare IO, version 4.0.2 or later.9-From the top Down arrow, select WiFi, verify that port 4000 is entered, and select Listen. At this point you

#1 Installed a Stratux a few months ago. Was working well with Avare.Recently my Avare lost GPS signal from Stratux. WIFI on tablet shows connected to Stratux WIFI with strong signal, but no position or data.I thought it just needed a GPS antenna upgrade. So, I replaced the internal GPS antenna with a wired, external GPS antenna. That made no change.Avare works fine when connected to bluetooth GPS receiver.What is likely wrong with the Stratux? #2 WIFI on tablet shows connected to Stratux WIFI with strong signal, but no position or data. Are you seeing the ADSB-in data? I know what was quoted, but I've learned to ask more specific questions, and thank for your patience.I assume this is on an iPad.There is a screen that lets you shut the Stratux down. Are you seeing any information about packets received?I'm asking to see if the problem can be localized to the GPS on the Stratux, or if there is a problem with the software running on the Raspberry Pi. #4 Are you seeing the ADSB-in data? I know what was quoted, but I've learned to ask more specific questions, and thank for your patience.I assume this is on an iPad.There is a screen that lets you shut the Stratux down. Are you seeing any information about packets received?I'm asking to see if the problem can be localized to the GPS on the Stratux, or if there is a problem with the software running on the Raspberry Pi. On an Asus TF700 android tablet.Not seeing any ADSB-in data, though I did for one flight after its GPS failed. Since then, none.I use the Avare external I/O plugin which used to show packets, still does when using the Garmin GPS antenna, but doesn't show any when just using the Stratux WIFI. #5

Thanks, will likely try this next time I am home. #6 Did you try accessing the stratux from a browser? It will tell you if it has gps and adsb. #7 Did you try accessing the stratux from a browser? It will tell you if it has gps and adsb. Haven't yet removed it from the plane. Will try after getting the plane home. thanks #8 You can do it from a browser on the tablet... which by the way is a way to get ahrs with avare #9 Installed a Stratux a few months ago. Was working well with Avare.Recently my Avare lost GPS signal from Stratux. WIFI on tablet shows connected to Stratux WIFI with strong signal, but no position or data.I thought it just needed a GPS antenna upgrade. So, I replaced the internal GPS antenna with a wired, external GPS antenna. That made no change.Avare works fine when connected to bluetooth GPS receiver.What is likely wrong with the Stratux? There is a Stratux app you can use to check what data it is sending. #10 Enter 192.168.10.1 in the web address box and look at the graphic user interface...it tells all. #11 Have you tried re-seating the GPS? The non-remote mount USB GPS can be unseated in rough air. I experienced that with my Stratux. #12 The USB plug can back out. Mine did that just from tossing it around in my flight bag...Jamming a piece of foam tape into the gap fixed the problem.I use a remote GPS antenna now, in order to keep the Stratux out of the sunlight and off the glareshield. #13 The USB plug can back out. Mine did that just from tossing it around in my flight bag...Jamming a piece of foam tape into the gap fixed the problem.I use

Should see data streaming below, if not go back and verify WiFi still connected... I observed many WiFi connections drop offs when near other sources.10-Restart Avare and be patient, you may not see any Wx, unless you are in the vicinity of transmitting stations on the ground, but should work above 3000 Ft., and if you are close to the airport you should see some traffic, Blue dots.Post here if you have any questions, or suggestions. #18 I had to flash my SD card once, but otherwise have had no issues over 2 years. No fiddling, no updating, just leave it in the plane and it works. #19 Installed a Stratux a few months ago. Was working well with Avare.Recently my Avare lost GPS signal from Stratux. WIFI on tablet shows connected to Stratux WIFI with strong signal, but no position or data.I thought it just needed a GPS antenna upgrade. So, I replaced the internal GPS antenna with a wired, external GPS antenna. That made no change.Avare works fine when connected to bluetooth GPS receiver.What is likely wrong with the Stratux? Did you check your stratux web interface for GPS connections and satellites?Thank youMohamed #20 Did you check your stratux web interface for GPS connections and satellites?Thank youMohamed Haven't been back to the plane since I last flew it and tried per my post #14 above: I entered 192.168.10.10 in a browser but it comes back as unable to connect in browser.Not sure if address is incorrect, I didn't try 192.168.10.1Will try 192.168.10.1 this Saturday when I return to the plane for another flight. #21 Flew last night. Here are pics from inflight.Can connect to Stratux WIFI but no GPS or traffic. #22 Flew last night. Here are pics from inflight.Can connect to Stratux WIFI but no GPS or

Traffic. It looks like it doesn’t work at all. The page are showing variables instead of values. Can you please share more about your design, software version, and hardware used?Thank youMohamed #23 It looks like it doesn’t work at all. The page are showing variables instead of values. Can you please share more about your design, software version, and hardware used?Thank youMohamed MohamedOriginally it was a Crewdog Stratux. It worked for a while, but when it failed I started this thread.I did this so far:I changed the GPS from the internal to a new external GPS - no changeStratux Vk-162 Remote Mount USB GPS flashed the sd card to the latest Stratux - no change.I followed this to do so:This was the filename:stratux-v1.6r1-377d22b403.imgI replaced the Raspberry PI board with a new raspberry pi 3 model B board - no change.Prior board was the same board. have purchased another microsd card and was planning on trying a different card. Waiting for its arrival to do so. #24 Which radios and antenna connections do you have? There are a few different models... #25 It looks like your stratux maybe goofy, but with the current version of Avare, you don't need the seperate IO module. #26 Which radios and antenna connections do you have? There are a few different models... Last edited: Mar 15, 2020 #27 Installed a different microsd card this morning with a fresh flash of Stratux.Same problems persist. #28 It seems very strange that you would have the same hardware or software error after all that. But I've gotten bad SDRs have you tried removing one or the other of the radios? #29 It seems very strange that you would have the same hardware or software error after all that. But I've gotten bad SDRs have you tried removing one